Real-time estimation of SAG mill charge characteristics for process optimisation
Join the AusIMM North West Queensland branch for their September technical session presented by Paul Toor from Toornado Metallurgy.
About this event
The Morrell C-model is generally regarded as one of the most accurate tumbling mill power-draw models and is ideally suited for this application of estimating fill levels of the SAG mill in real time.
This presentation will summarise three methods of using the Morrell C-model to estimate total and ball charge volumes for SAG mills, depending on the data and measurements available. The methodologies outlined all allow analysis of real-time data and large data sets spanning months and years of operation, thus facilitating identification of optimum operating conditions and aiding in early detection, trouble-shooting, and rectifying poor mill performance.
Join us to find out more.
Speaker/s
Paul Toor
Paul’s experience in all aspects of the industry from site based roles, services, OEM and consultancy allow him to provide holistic and practical solutions to his clients. In particular, Paul is a recognised expert in SAG mills and liner design having written numerous papers on the subject and conducted work globally.
Location
Buffs Club, Lodge Room
35 Grace Street, Corner of Grace and Simpson Street
Mount Isa, QLD 4825
Wednesday, 25 September 2024
6.30pm – 9.30pm (UTC+10:00)
Date and Time
6.30pm – 9.30pm (UTC+10:00)
Venue
35 Grace Street, Corner of Grace and Simpson Street
Mount Isa, QLD 4825
Cost
Non-Member: Free