Mr. P. F. THOMPSON said this matter was one of very great importance to producers of lead. His association with the matter was that he happened to be the Institute representative on the Committee of the Standards Association of Australia charged with formulating a standard for chemical lead, that is, lead used in technical chemistry for acid chambers and the like. The British standard had this test incorporated in it, but those on the committee felt that it should not be included in the specification. The main objection was that in an accelerated corrosion test one was endeavouring to do in a few seconds what in natural conditions would take years; and it was now being recognised that such tests were of little value in assessing the corrosive properties of a metal.The flash point test was carried out with boiling hot strong sulphuric acid; but no chemical manufacturer would be likely to use such in contact with lead. There were many factors such as the formation of steam, the chemical reduction of sulphuric acid, the evolution of hydrogen, the catalytic effect of the surface lead, affecting this test, other than the presence of the segregated impurities upon which this test throws the onus of the whole imperfection of the lead. Mr. Russell had shown that lead which had stood the test of time often gave a low flash point. They were endeavouring to find rapid methods of estimating minute amounts of the more important impurities, which would eliminate the labour and expense of a full analysis.Mr. H. St. J. SOMERSET thanked Mr. Thompson for his remarks. He supposed some of those present knew that the Broken Hill Associated Smelters was responsible for Mr. Russell's investigations at the University, and he could only agree with Mr. Thompson that the flash point test, which had been accepted at the present time...